Automotive Can Bus System Training Equipment

Guangdong Zhongcai Education Equipment Co.,Ltd. is one of the most reliable manufacturers and suppliers of automotive can bus system training equipment in China. Welcome to buy high quality engineering education equipment from our factory. Also, OEM&ODM service is available.

Automotive Can Bus System Training Board

Electrical and Communication Parameters

Power Supply: AC 220V±10% 50/60Hz, internally rectified to DC 12V system voltage.

Bus Electrical Characteristics: CAN-H/CAN-L twisted-pair differential transmission; recessive level voltage difference <0.5V, dominant level >0.9V; static CAN-H≈2.5V, CAN-L≈2.5V (drive system) or CAN-H≈0V/5V, CAN-L≈5V/0V (comfort system specific logic).

Termination Matching: 120Ω resistors are configured at each end of the bus, resulting in a parallel bus termination impedance of approximately 60Ω.

Communication Rate: High-speed CAN (powertrain/chassis) typically 500kbps (maximum 1Mbps), low-speed CAN (comfort/body) typically 100kbps (some older models 62.5kbps). Fault Simulation: Supports fault settings such as open circuit, short circuit to ground/power supply, and missing terminal resistor, with fault indication and clearing functions.

Physical Specifications and Environmental Adaptability

Dimensions: Common range: Length 1740-2400mm × Width 600-700mm × Height 1700-1800mm (including moving platform).

Operating Environment: Temperature -40℃~+50℃, relative humidity ≤80% (non-condensing).

Power Consumption: Total power approximately 350W (including lighting and module operation).

Structural Materials: The platform is made of square tube/angle iron welded and powder-coated; the panel is 4mm thick aluminum-plastic composite plate; the bottom is equipped with universal self-locking casters.

Configuration and Functional Components

Core Modules: Engine ECU, Transmission ECU, ABS/ESP module, instrument cluster, gateway, four-door control unit (comfort system teaching board). Testing Interfaces: The panel integrates an OBD-II diagnostic connector and numerous test terminals, supporting multimeter voltage/resistance measurements, oscilloscope waveform measurements, and decoder code/data stream reading.

Teaching Aids: Color original vehicle schematic panel, ignition switch, fault setting box (wireless/button type), and experiment manual.

Hot Tags: automotive can bus system training equipment, China, manufacturers, suppliers, engineering, OEM, ODM, car accessory, car engine and accessories, common rail testing kit, diesel engine running model, engine for vocational training, operational engine