Product features:
Chevrolet Cruze disassembly and operation training platform (national competition model)
Model: ZCA-45
Technical parameters:
| Working power: | DC 12V |
| Fuel label: | According to engine model |
| Fuel tank volume: | 10L |
| Operating temperature: | -40℃～+50℃ |
Product introduction:
The equipment is composed of two parts: a disassembly and flipping bench equipped with a Chevrolet Cruze 1.6LED electronically controlled gasoline engine assembly (easy to disassemble) and a running inspection console. The disassembly and assembly turning stand provides trainees with engine disassembly and assembly training. After the engine is assembled, it can be connected to the operation inspection console, and the engine can be started and operated to test the assembly effect of the engine. It is suitable for the teaching needs of automobile engine and maintenance training in middle and higher vocational and technical colleges, general education colleges and training institutions.
Features:
1. A real and operational electronically controlled gasoline engine, fully demonstrating the composition and working process of the electronically controlled gasoline engine.
2. The training platform consists of two parts: the disassembly and assembly of the overturning platform and the operation and detection console. The disassembly and reversing bench is composed of an electronically controlled gasoline engine assembly and an engine disassembly and assembly frame that can be turned 360 degrees. The operation detection console is composed of a control panel, an engine electronic control unit, a cooling system, an oil supply system, and a battery.
3. The disassembly and reversing stand with the reducer can be turned over and stationary at any axial angle, and can be easily disassembled and assembled for training. An oil tray is placed at the bottom to facilitate the collection of small parts, water and oil. To three do not land.
4. The operation inspection console frame is equipped with all the components for starting and running the engine, such as electronic control unit, water tank, oil tank and oil pump, instrumentation, ignition switch, etc. It can run the engine and check the effect of engine assembly.
5. The color inkjet circuit diagram is drawn on the panel of the training platform, and the inkjet diagram is protected by 3mm thick plexiglass. Students can intuitively compare the circuit diagram and the actual engine to understand and analyze the working principle of the control system.
6. There are detection terminals installed on the panel of the training platform, which can directly detect the electrical signals of the pins of each sensor, actuator, and engine control unit on the panel, such as resistance, voltage, current, frequency signals, etc.
7. There are automobile instruments, fuel pressure gauges, and vacuum pressure gauges installed on the panel of the training platform, which can display the changes of parameters such as engine speed, fuel injection pressure, and intake manifold pressure in real time.
8. The training bench is equipped with a diagnostic base, which can be connected to a dedicated or general-purpose car decoder to query the engine electronic control system for ECU code query, read fault codes, clear fault codes, read data streams, execute component testing, and parameter setting. Self-diagnosis functions such as setting and waveform analysis.
9. The training platform is equipped with installation protection devices such as the main power switch and the flywheel protective cover.
10. The base of the training platform is welded by steel structure, and the surface is treated by spraying process.
11. Equipped with intelligent fault setting and assessment system
Technical parameter:
1. Working power supply: DC 12V
2. Fuel label: according to the engine model
3. Fuel tank volume: 10L
4. Working temperature: -40℃～+50℃
